PLANTOMOULD N / S

Home > Products > Product Review > Mould Release Agents > PLANTOMOULD N / S >


Product Review

	Engine and Gear Oils

	Mould Release Agents

		RENOCAST STANDARD

		RENOCAST PERFECT

		RENOCAST DES 8

		RENOCAST 121

		PLANTOMOULD N / S


	Metalworking Fluids

	Metalforming Lubricants

	Corrosion Preventives

	Quenching Oils

	Greases

	Industrial Lubricants

	Rapidly Biodegradable Lubricants

	Other products and services



Publication

Exhibitions

FUCHS for REACH - The new EU chemical law

EURO PI

PLANTOMOULD N / S

Rapidly biodegradable mould release oils

Considerable quantities of mould release oils pollute the environment when decorative concrete, precast concrete sections and concrete sleepers are being cast.

PLANTO MOULD RELEASE OILS based on environmentally safe raw materials present an ecological alternative to the mineral-oil-based mould release agents. PLANTO MOULD RELEASE OILS are biodegradable and thus harmless to the fauna and flora.

PLANTO MOULD RELEASE OILS have the following features:

Simple, reliable and clean mould removal.

Good economy.

A film of the mould release agent temporarily protects metal parts from corrosion and does not corrode non-ferrous metals.

Almost complete inhibition of blowhole and pore formation and staining.

The PLANTO MOULD RELEASE OILS S and N were awarded the "Blue Angel" environmental seal by the Deutsche Institut für Gütesicherheit und Kennzeichnung e.V. (RAL).

Application:

PLANTO MOULD RELEASE OILS

can be applied to all commonly used shuttering systems using coated chipboard, steel, wood, etc.
A compatibility check shall be made prior to industrial applications, because the application and ambient conditions may influence the properties of the concrete surface and consumption of the mould release oil.

may be applied manually with a brush or oil-resistant spraying device.

mixing with mineral oil or solvents is not at all environmentally safe.

cannot be used for the protection of mixers and machinery, because they may attack lacquer, eastomers or plastic parts in the worst case.

dissolve Styropor if applied all-over. Damage to Styrodur (green) will be less severe. If contact with this material cannot be avoided reduce the quantity to be applied.

are ready-to-use and shall not be diluted with solvents.

Characteristics:

Properties	Unit	PLANTOMOULD		Test method
		S	N
Colour		0.5	0.5	DIN ISO 2049
Density	kg/m³	886	905	DIN 51 757
Temperature range	°C max.	80	60
Viscosity at 20 °C	mm²/s	8.1	23.7	DIN 51 562
Flashpoint	°C	180	194	DIN ISO 2592
Application		spray	brush
Biodegradability after 21 days	%	> 90	> 90	CEC-L-33-T-82

Safety information:

Observe local water regulations.
Avoid open flames.
Do not smoke.
Do not inhale spray mist.
Avoid skin and eye contact.
Change product-soaked clothing.
Observe industrial hygiene regulations.

Disclaimer of Liability