ANTICORIT DFW

Home > Products > Product Review > Corrosion Preventives > ANTICORIT DFW >


Product Review

	Engine and Gear Oils

	Mould Release Agents

	Metalworking Fluids

	Metalforming Lubricants

	Corrosion Preventives

		ANTICORIT RP4107 S

		ANTICORIT PL3802 LV

		ANTICORIT OHK

		ANTICORIT MKR

		ANTICORIT DFW

		ANTICORIT DFO

		ANTICORIT DF

		ANTICORIT BW 366

		ANTICORIT 6120/42

		ANTICORIT 5012 S

		ANTICORIT 03 W-C


	Quenching Oils

	Greases

	Industrial Lubricants

	Rapidly Biodegradable Lubricants

	Other products and services



Publication

Exhibitions

FUCHS for REACH - The new EU chemical law

EURO PI

ANTICORIT DFW

Corrosion Protection Oil and Dewatering Fluid

ANTICORIT DFW is a corrosion preventive and dewatering fluid which, when the solvent evaporates, forms a soft, waxy-oily film. This offers excellent corrosion protection, intensive dewatering properties, stability against dragged-in acids and alkalines along with being extremely economical.

ANTICORIT DFW is recommended for the rapid drying and simultaneous protection of metal components and tools; after galvanizing and washing processes for the interim and long-term protection of bare metal surfaces.

ANTICORIT DFW gives galvanized screws a consistent coefficient of friction. Even if the fastener is repeatedly retightened the torque variation remains minimal. The product allows automatic screw and nut drivers with preset torques to work with the utmost of accuracy and reliability.

ANTICORIT DFW complies with the VW TL 52 111 and FORD SZ 600 A specifications concerning friction coefficients and additionally offers good corrosion protection.

Application:
Normally by dipping but if such facilities are not available ANTICORIT DFW can be sprayed. However, all precautions applicable to solvent-based products should be observed. If necessary, please consult the corresponding Material Safety Data Sheet.
If sealed in the original container, ANTICORIT DFW can be stored for min. 5 years at 5 - 40 °C.

Characteristics:

Properties	Unit	Value	Test method
Colour		5.0	ASTM D 1500
Flashpoint	°C	40	ASTM D 56
Density at 15 °C	kg/l	0.820	ASTM D 1258
Viscosity at 20 °C	mm²/s	2.2	ASTM D 445
Film weight	g/m²	0.9	FLP-F 3 *)
Evaporation residue	%	22	FLP-V 1 *)
Corrosion Protection Data (on RRSt. 1405 m test panels)
Humidity cabinet	hours	300	ASTM D 1748
Salt spray test	hours	24	ASTM B 117
Condensation climate	cycles	30	DIN 50 017 KFW

*)	= FUCHS Laboratory procedure

Disclaimer of Liability