RENOLIT CXI 2

Home > Products > Product Review > Greases > RENOLIT CXI 2 >


Product Review

	Engine and Gear Oils

	Mould Release Agents

	Metalworking Fluids

	Metalforming Lubricants

	Corrosion Preventives

	Quenching Oils

	Greases

		RENOLIT SO-GFB

		RENOLIT MO 2

		RENOLIT LZR 000

		RENOLIT LX-EP 2

		RENOLIT GP 2

		RENOLIT G-HT 2

		RENOLIT EPLITH 00

		RENOLIT EP 2

		RENOLIT CXI 2

		RENOLIT CA-G 2

		RENOLIT CA-B 2

		RENOLIT AX-2 FG 1

		PLANTOGEL 2 S

		PLANTOGEL 2 N

		PLANTOGEL 000 S


	Industrial Lubricants

	Rapidly Biodegradable Lubricants

	Other products and services



Publication

Exhibitions

FUCHS for REACH - The new EU chemical law

EURO PI

RENOLIT CXI 2

Calcium Complex Grease for Severe Conditions

RENOLIT CXI 2 was developed to work under severe conditions in roller and plain bearings in steel mills, paper industry, mining, concrete, quarries, construction equipment.

RENOLIT CXI 2 should be used for all lubricating points requiring a high performance concerning water resistance, working stability, EP and AW properties.

RENOLIT CXI 2 is easily pumpable even in long tubes, feed by centralized lubricating systems.

RENOLIT CXI 2 is a optimized Calcium-Complex thickened grease based on selected base oils.

RENOLIT CXI 2 shows very good characteristics concerning water resistance, even concerning acids and alkaline solutions, working stability, corrosion protection and oil bleeding.

Characteristics:

Properties	Unit	Value	Test method
Thickener		lithium soap
Temperature range	°C	- 20 to 160
Dropping point	°C	190	ISO 2176/ASTM D 566
NLGI grade		2
Worked penetration	0.1 mm	265 - 295	ISO 2137/ASTM D 217
Working stability, difference after 100,000 strokes	0.1 mm	<15	ISO 2137/ASTM D 217
Water-spray-off	%	5	ASTM D 4049
Water-wash-out at 40 °C	%	0,5	IP 215
Rust inhibiting properties SKF-Emcor with 3% NaCl	degree of corrosion	0 and 1	DIN 51802/IP 220
Base oil viscosity at 40°C	mm²/s (cSt)	app. 300	ISO 3104/ASTM D 445
Oil separation at 40 °C/18h	% Wt.	<0,1 K	DIN 51817/IP 121
Oil separation at 120 °C/7h	% Wt.	<1	DIN 51817/IP 121
Four ball EP-test, weld load	N	>5000	ASTM D 2596
Timken OK load	lbs.	55	ASTM D 2509
DIN classification		KP 2 P-20	DIN 51825
ISO classification		L-XBEIB 2	ISO 6743-9

Disclaimer of Liability