Specifically developed for the roller bearing industry, ANTICORIT 03 W-C is a barium-free, thixotropic corrosion protection concentrate.
ANTICORIT 03 W-C fulfils the specific corrosion protection requirements of the roller bearing industry along with being fully compatible with subsequently applied lubricants.
ANTICORIT 03 W-C is normally diluted with solvents and after evaporation, forms a stable film which allows pleasant handling and rapid packing.
ANTICORIT 03 W-C is suitable for the protection of noise-suppressing, deep-groove roller bearings and is approved by SKF.
Application:
ANTICORIT 03 W-C can be applied by spraying, dipping or flooding when diluted with solvents such as:
Chlorinated hydrocarbons
Chloro-fluoro hydrocarbons
White spirits.
Observe all precautions applicable to solvent-based products. If necessary, please consult the corresponding Material Safety Data Sheet. The film thickness can be varied by adjusting the type and quantity of solvent. Group 1 and 2 solvents afford the most rapid film drying.
ANTICORIT 03 W-C's thixotropic properties may cause slight thickening after longer periods of storage.
The original viscosity can be stored by stirring.
If sealed in the original container, ANTICORIT 03 W-C can be stored for min. 5 years at 5-40°C.
Characteristics:
Properties
Unit
Value
Test method
Colour
 
7.5
ASTM D 1500
Density at 15 °C
kg/l
0.912
ASTM D 1298
Viscosity at 50 °C
mm²/s
100
ASTM D 445
Flashpoint
°C
150
ASTM D 92
Film thickness
µm
min. 10
SFK AV D 25
Solid impurities
% mass
< 0.03
DIN 51 592
Corrosion Protection Data (on CK 22 test panels)
 
 
 
Humidity cabinet
hours
> 500
ASTM D 1748
Salt spray test
hours
> 250
FLP-K 19*)
Condensation climate
cycles
> 60
DIN 50 017 KFW
Roller test
 
OK
SKF-AV-D-25
Fingerprint Corrosion
 
 
 
Hand perspiration/oil
 
OK
SKF-AV-D-25
Oil/Hand perspiration
 
OK
SKF-AV-D-25
Corrosive effect on Ms 63 brass (24 hours at 100° C)